Lot of 2 Richelieu Center Mount Drawer Slide 22” Steel - Ball Bearing

Lot of 2 Richelieu Center Mount Drawer Slide 22” Steel - Ball Bearing Slide

These measure 21 inches long with a 3 inch back socket, so you have adjustability between 21 to approximately 23 inches. The width is inch and 3/8 and the thickness is approximately 5/16. Comes with mounting hardware and instructions.

35 pound capacity

Looks to be about a three-quarter extension.

ASSEMBLY INSTRUCTIONS

To use the T35072G22 center slide, the drawer side must extend below the drawer bottom 1/4". (Fig. 1) It may be necessary to cut a notch in the back overhang of the drawer, allowing the slide to fully extend to the back of the cabinet.

NOTE: A shim equal to the amount of extension greater than 1/4" should be installed below the cabinet part. Example: 3/8" drawer side extension requires a 1/8" shim. (Fig.2) Separate the drawer and cabinet part by pulling firmly through the friction resistance. Measure and mark the center line of the drawer width and the cabinet opening.

G2 HW.